Tips&Tricks59 Videos

0

13:31

How To Replace The Flywheel Bolts On Your Sea-Doo PWC

In this video we show the steps to replace your OEM flywheel bolts on your Sea-Doo personal water craft. This is a necessity if you remove your rev limiter and operate above 8,100 RPM.

Axel

6 years ago

285

24

04:20

Yamaha Wave Runner impeller housing

Corrosion causes the impeller housing to warp or dimple. When you try to start the engine you get a loud “clunk” or it just won’t turn over. This is the best place to get your parts…..fast ….courteous….and great prices. http://www.atlanticjetsport.com/index.php

Axel

10 years ago

42.83K

0

07:26

How to Rebuild Your Sea-Doo Jet Pump

This how-to video shows all the steps required to rebuild a Sea-Doo jet pump on a 2009 RXT 215 Sea-Doo.

Axel

7 years ago

245

150

05:59

How to Replace a Jet Ski Wear Ring on a 4-TEC Sea-Doo

Full instructions for wear ring replacement on Sea-Doo 4-Tec watercraft. Performed on a 2012 GTR 215 with iBR (intelligent Brake and Reverse), this video takes you step by step through the process. You can find products featured in this video at our 3ftDeep Store: http://www.3ftDeepSports.com Required Parts and Service Products: XPS Lube (293 600 016; […]

Axel

9 years ago

47.10K

0

06:36

How To: Engine Alignment on a Sea-Doo PWC

A short video outlining the steps to vertically align the engine of your Sea-Doo personal watercraft. Performed on a 2012 GTR 215 Sea Doo, it shows the additional steps required when the engine mount retaining screws fail.

Axel

7 years ago

303

2

02:03

How To: Antifreeze Exhaust Flush for Sea-Doo

In this how-to video we show you how we protect our exhaust system from the threat of a freezing winter by pumping (non-toxic)

Axel

8 years ago

1.47K

1

02:02

Top 10 Reasons To Own A Personal Water Craft

These are the indisputable top 10 reasons to own a personal water craft!

Axel

6 years ago

275

11

05:40

How To Install the Sea-Doo X Package Module (on a 4-TEC 2012 GTR 215)

This video shows how to install the X Package Module on a 2012 Sea Doo GTR 215 jet ski. Sincere apologies in advance for the following flubs: 1) the battery on my Go Pro died 2/3 of the way through, so it’s not a complete video; 2) I show the connector being unplugged twice; and […]

Axel

10 years ago

7.92K

0

09:21

How to set up your Anchor for Kayak, Jetski, Boat, Standup paddle board

How to set up the rope and chain on your boat anchor for Kayaks, Stand up paddle boards, Jetskis and Boats.

Axel

7 years ago

192

213

09:43

How to Rebuild a 4-TEC Jet Ski Supercharger (on a 2005 Sea-Doo GTX 185)

All 185 HP and higher Sea-Doo machines eventually need a supercharger rebuild. Normally performed between 100 and 200 hours, this video goes through step by step instructions on rebuilding a Sea-Doo supercharger on a 2005 GTX 185. You can find products featured in this video at our 3ftDeep Store: http://www.3ftDeepSports.com. If you don’t want to […]

Axel

9 years ago

61.61K

0

05:20

How to Ride a Stand Up Jet Ski – The Basics

Axel

7 years ago

640

0

04:06

How To Install a GPS Speedometer Module (CanDooPro)

Full instructions for installing a CanDooPro GPS Speedomoeter Module (part no. 9501) for 1997 to 2006 Sea-Doo models with lake temperature sensor.

Axel

8 years ago

958